DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
62
The fields that can be configured are described below:
Parameter Description
IPv6 Address
Enter the binding entry IPv6 address to be displayed or cleared here. Select the
All option to display or clear all DHCPv6 client prefix bindings in or from the
binding table.
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to clear the entries based on the information specified.
DHCPv6 Server Interface Settings
This window is used to display and configure the DHCPv6 server interface settings.
To view the following window, click Management > DHCP > DHCPv6 Server > DHCPv6 Server Interface Settings,
as shown below:
Figure 4-423 DHCPv6 Server Interface Settings Window
The fields that can be configured are described below:
Parameter Description
Interface VLAN Enter the interface VLAN ID here. The range is from 1 to 4094.
Pool Name Enter the DHCPv6 server pool name here. This name can be up to 12
characters long.
Rapid Commit
Select to enable or disable two-message exchange here. By default, two-
message exchange is not allowed.
Preference Enter the preference value here. Select the Allow Hint option to allow hints.
Interface Name Enter the interface name here.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
DHCPv6 Server Operational Information
This window is used to display the DHCPv6 server operational information.
To Next Page
Loading...
