DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
111
802.1p Default Priority
The Switch allows the assignment of a default 802.1p priority to each port on the Switch.
In the QoS folder, click 802.1p Default Priority to view the window shown below.
Figure 8- 4. 802.1p Default Priority window
This page allows the user to assign a default 802.1p priority to any given port on the Switch. The priority tags are numbered from
0, the lowest priority, to 7, the highest priority. To implement a new default priority, first choose a port range by using the From
Port and To Port pull-down menus and then use the Priority drop-down menu to select a value from 0 to 7. Click Apply to
implement the settings.
802.1p User Priority
The Switch allows the assignment of a class of service to each of the 802.1p priorities.
In the QoS folder click 802.1p User Priority, to view the window shown below.
Figure 8- 5. 802.1p User Priority window
Once a priority has been assigned to the port groups on the Switch, then a Class may be assigned to each of the seven levels of
802.1p priorities using the drop-down menus on this window. Click Apply to set the changes.
To Next Page
Loading...
