DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
44
MAC Address Aging Time
To configure the MAC Address Aging Time on the Switch, click Configuration > MAC Address Aging Time:
Figure 6- 22. MAC Address Aging Time window
Enter a value between 10 and 875 seconds.
The following parameter may be configured or viewed:
Parameter Description
MAC Address
Aging Time (10-
875)
This field specifies the length of time a learned MAC Address will remain in the forwarding table
without being accessed (that is, how long a learned MAC Address is allowed to remain idle). To
change this, type in a different value representing the MAC address age-out time in seconds.
The MAC Address Aging Time can be set to any value between 10 and 875 seconds. The
default setting is 300 seconds.
Click Apply to set the MAC Address Aging Time.
Web Settings
To configure Web Status on the Switch, click Configuration > Web Settings:
Figure 6- 23. Web Settings window
The following parameters may be configured or viewed:
Parameter Description
Web Status
Web-based management is Enabled by default. If you choose to disable this by clicking
Disabled, you will lose the ability to configure the system through the web interface as soon as
these settings are applied.
Port
The TCP port number used for Web-based management of the Switch. The "well-known" TCP
port for the Web protocol is 80.
Click Apply to set the Web settings.
To Next Page
Loading...
