D-Link DGS-3200 SERIES - SNMP Engine ID; SNMP Trap Configuration

DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
61
The following parameters can set:
Parameter Description
Host IPv6 Address
Type the IP address of the remote management station that will serve as the SNMP host for
the Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
V2c - To specify that SNMP version 2c will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Community String /
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click Apply.
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string used to identify the
SNMP engine on the Switch. To display the Switch's SNMP Engine ID, open the SNMP Settings folder located in the
Configuration folder and click on the SNMP Engine ID link. This will open the following window, as shown below.
Figure 6- 42. SNMP Engine ID window
To change the Engine ID, type the new Engine ID in the space provided and click the Apply button.
SNMP Trap Configuration
The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click Configuration > SNMP Settings > SNMP Trap Configuration:
Figure 6- 43. SNMP Trap Configuration window
To enable or disable the Traps State and/or the Authenticate Traps State, use the corresponding pull-down menu to change and
click Apply.