DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
45
Telnet Settings
To configure Telnet Settings on the Switch, click Configuration > Telnet Settings:
Figure 6- 24. Telnet Settings window
The following parameters may be configured or viewed:
Parameter Description
Telnet Status
Telnet configuration is Enabled by default. If you do not want to allow configuration of the
system through Telnet choose Disabled.
Port
The TCP port number used for Telnet management of the Switch. The "well-known" TCP port for
the Telnet protocol is 23.
Click Apply to set the Telnet setting.
Password Encryption
To configure Password Encryption on the Switch, click Configuration > Password Encryption:
Figure 6- 25. Password Encryption window
The following parameter may be configured or viewed:
Parameter Description
Password
Encryption
Status
Password encryption is Disabled by default. To enable password encryption, click the Enabled
radio button.
Click Apply to set the Password Encryption.
To Next Page
Loading...
