DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
71
Firmware Upgrade
The Commander Switch may be used for firmware upgrades of member switches. To access the following window, click
Configuration > Single IP Management > Firmware Upgrade. Member Switches will be listed in the table and will be
specified by Port (port on the CS where the MS resides), MAC Address, Model Name and Version. To specify a certain Switch
for firmware download, click its corresponding check box under the Port heading. To update the firmware, enter the Server IP
Address where the firmware resides and enter the Path/Filename of the firmware. Click Download to initiate the file transfer.
Figure 6- 60. Firmware Upgrade window for Single IP Management
Configuration File Backup/Restore
The Commander Switch can instruct configuration file backup and restore to the Member Switch using a TFTP server. Member
Switches will be listed in the table and will be specified by Port (port on the CS where the MS resides), MAC Address, Model
Name and Version. To specify a certain Switch for upgrading configuration files, click its corresponding radio button under the
Port heading. To update the configuration file, enter the Server IP Address where the file resides and enter the Path/Filename of
the configuration file. Click Restore to initiate the file transfer from a TFTP server to the Switch. Click Backup to backup the
configuration file to a TFTP server.
Figure 6- 61. Configuration File Backup/Restore window for Single IP Management
Upload Log File
The Commander Switch can order a log file from a member switch sent to a server. Provide the Server IP address for storing the
log and the log file path and filename on the member switch. Click Upload to send the log file to a TFTP server.
Figure 6- 62. Upload Log File window for Single IP Management
To Next Page
Loading...
