DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
29
Serial Port Settings
This window allows a user to adjust the Baud Rate and the Auto Logout values.
To enter serial port settings for the Switch:
Open the Configuration folder and click Serial Port Settings to open the following window:
Figure 6- 3. Serial Port Settings window
Baud Rate This field specifies the baud rate for the serial port on the Switch. There are four possible
baud rates to choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch
using the CLI interface, the baud rate must be set to 115200, which is the default setting.
Auto Logout Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2 mins, 5 mins, 10 mins,
15 mins or Never. The default setting is 10 mins.
Click Apply to implement changes made.
To Next Page
Loading...
