DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
151
Section 10
ACL
Access Profile List
CPU Access Profile List
Time Range Settings
Access Profile List
Access profiles allow you to establish criteria to determine whether the Switch will forward packets based on the information
contained in each packet's header.
The Switch supports four Profile Types, Ethernet ACL, IPv4 ACL, IPv6 ACL, and Packet Content ACL.
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch will
examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the Switch will use
to determine what to do with the frame. The entire process is described below in two parts.
To display the currently configured Access Profiles on the Switch, open the ACL folder and click the Access Profile List link.
This will open the Access Profile List window, as shown below (one access profile of each type has been created for explanatory
purposes).
Figure 10- 1. Access Profile List window
To add an entry to the Access Profile List window, click the Add ACL Profile button. To remove all access profiles from this
table, click Delete All.
This will open the Add Access Profile window, as shown below. There are four Add Access Profile windows; one for Ethernet
(or MAC address-based) profile configuration, one for IPv6 address-based profile configuration, one for IPv4 addres-based profile
configuration, and one for packet content profile configuration.
The window shown below is the Add ACL Profile window for Ethernet:
To Next Page
Loading...
