D-Link DIR-895L

101D-Link DIR-895L User Manual
Section 4 - Conguration - Extender Mode
Conguration - Extender Mode
Settings
Enter your password. If you previously followed the setup wizard, please use the admin
password you entered during the wizard. Otherwise, leave the password blank. Click Log
In to proceed.
Note: If you cannot remember your password and cannot log in, press the reset button on the
back of the device for longer than 10 seconds to restore the router to its default settings.
If you are having trouble logging in or experiencing trouble with the conguration utility, try
clearing your browser cache or try using your web browser's 'private browser' or incognito
mode.
To access the conguration utility, open a web browser such as Internet Explorer and enter
http://dlinkrouter.local./ or you may also connect by typing the IP address* of the DIR-895L
in the address bar.
* By default the DIR-895L in access point mode will use DHCP to obtain an IP address from
your uplink network. If you are using multiple DIR-895Ls or D-Link devices, go to http://
dlinkrouterxxxx.local./ as shown on the included Wi-Fi Conguration Card, with “xxxx”
being the last four digits of the DIR-895L’s MAC address. The MAC address is also printed on
the label on the bottom of the device. The web conguration utility may also be accessed
at the IP address 192.168.0.50 when in Extender Mode.
DIR-895L HW:A1 FW:1.12
Internet DIR-895L
Connected Clients: 1
USB Device
Internet Connected
Click on any item in the diagram for more information.
Settings ManagementHome
The device's Home Page will open, giving you quick access to the DIR-895L's current status.
The bar at the top of the page has quick access to the Home, Settings, and Management
functions.
Note: The system will automatically log out after a period of inactivity.
Admin Password:
Log In