D-Link DIR-895L

62D-Link DIR-895L User Manual
Section 4 - Conguration - Router Mode
IPV6 in IPV4 Tunnel
The user can congure the IPv6 connection to run in IPv4 Tunnel mode. IPv6 over IPv4
tunnelling encapsulates IPv6 packets in IPv4 packets so that IPv6 packets can be sent over
an IPv4 infrastructure.
Remote IPv4
Address:
Enter the IPv4 remote address you will use.
Remote IPv6
Address:
Enter the IPv6 remote address you will use.
Local IPv4
Address:
Displays the current local IPv4 address.
Local IPv6
Address:
Enter the IPv6 local address you will use.
Subnet Prex
Length:
Enter the subnet prex length supplied by your ISP.
IPv6 DNS Settings
DNS Type: Select either Obtain DNS server address automatically or Use the
following DNS address.
If Use the following DNS address is selected:
Primary DNS
Server:
Enter the primary DNS server address.
Secondary DNS
Server:
Enter the secondary DNS server address.
My Internet Connection is: IPV6 in IPV4 tunnel
⌵
DIR-895L HW:A1 FW:1.12
Settings >> Internet >> IPv6
SettingsHome Features Management
Remote IPv4 Address:
Remote IPv6 Address:
Local IPv4 Address: Not Available
Local IPv6 Address:
Subnet Prex Length:
IPv4
Save
IPv6
All of your IPv6 Internet and network connection details are displayed on this page.
DNS Type: Obtain a DNS server address automatically
⌵
IPv6 DNS SETTINGS
DNS Type: Use the following DNS address
⌵
Primary DNS Server:
Secondary DNS Server:
IPv6 DNS SETTINGS