D-Link DIR-895L

75D-Link DIR-895L User Manual
Section 4 - Conguration - Router Mode
Advanced Settings - DHCP Server
Status: Enable or disable the DHCP server.
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you statically (manually) assign IP addresses to your computers
or devices, make sure the IP addresses are outside of this range or you
may have an IP conict.
DHCP Lease Time: Enter the length of time for the IP address lease in minutes.
Always Broadcast: Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100
Mbps, 1000 Mbps, or Auto (recommended).
UPnP: Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
IPv4 Multicast
Stream:
Enable to allow IPv4 multicast trac to pass through the router from
the Internet.
IPv6 Multicast
Stream:
Enable to allow IPv6 multicast trac to pass through the router from
the Internet.
Click Save when you are done.
Network (continued)
DHCP Server
Advanced Settings
Status:
Enabled
DHCP IP Address Range: 192.168.0. 100 to 192.168.0. 199
DHCP Lease Time:
10080 minutes
Always Broadcast:
Enabled
(compatibility for some DHCP Clients)
WAN Port Speed: Auto
⌵
UPnP:
Enabled
IPv4 Streams:
Enabled
IPv6 Multicast Streams
Enabled
COPYRIGHT © 2016 D-Link
DIR-895L HW:A1 FW:1.12
Settings >> Network
SettingsHome
Network
Features Management
Use this section to congure the network settings for your device. You can enter a name for your device in
the management link eld, and use the link to access web UI in a web browser. Recommend to change the
management link if there are more than one D-Link devices within the network.
Network Settings
Advanced Settings ...
LAN IP Address: 192.168.0.1
Subnet Mask:
255.255.255.0
Management Link: http://
dlinkrouter .local/
Local Domain Name:
Enable DNS Relay:
Enabled
Save