D-Link DSL-G2452DG - Page 39

35D-Link DSL-G2452DG User Manual
Section 4 - Configuration
PPPoE (Cont)
Advanced Settings
Address Mode: Select Static IP if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP. Static IP only.
Service Name: Enter the ISP service name (optional).
Primary DNS
Server:
Enter the primary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
Secondary DNS
Server:
Enter the secondary DNS server IP address assigned by your ISP. This
address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Enable NAT: Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 37 or click Save when you are done.