57D-Link DSL-G2452DG User Manual
Section 4 - Configuration
Static Routes
The Static Routes section allows you to define custom routes to control how data traffic is
moved around your network.
In the Features menu on the bar on the top of the page, click Static Routes.
To configure IPv6 rules, click IPv6 and refer to IPv4 on page 57. To return to the main
IPv4 static routes page, click IPv4.
If you wish to remove a rule, click on its trash can icon in the Delete column. If you wish
to edit a rule, click on its pencil icon in the Edit column. If you wish to create a new rule,
click the Add Rules button. Click Save when you are done. If you edit or create a rule, the
following options will appear:
Create New Rule
Destination
Network:
Enter the IP address of packets that will take this route.
Mask: Enter the netmask of the route.
Gateway: Enter your next hop gateway to be taken if this route is used.
Metric: The route metric is a value from 1 to 16 that indicates the cost of using
this route. A value 1 is the lowest cost and 16 is the highest cost.
Interface: Select the interface that the IP packet must use to transit out of the
router when this route is used.
Click Apply and Save when you are done.
IPv4
To Next Page
Loading...
Need help?
General
