D-Link DSL-G2452DG - Page 50

46D-Link DSL-G2452DG User Manual
Section 4 - Configuration
DHCP Lease Time: Enter the length of time for the IP address lease in minutes.
Secondary IP
Status: Enable or disable the Secondary IP.
LAN IPv6 Address Settings
Enable DHCP-PD: Enable or disable DHCP-PD (Dynamic Host Configuration Protocol -
Prefix Delegation).
Note: This feature requires a smaller subnet prex than /64 (i.e. allowing
for a larger address allocation), such as /63. Contact your ISP for more
information.
If you disabled DHCP-PD, enter the LAN IPv6 PD Address subnet prefix:
LAN IPv6 PD
Address:
Enter the LAN IPv6 PD Address subnet prefix.
LAN IPv6 Link-
Local Address:
Displays the router’s LAN IPv6 link-local address.
Advanced Settings - Address Autoconguration Settings
Enable Automatic
IPv6 Address
Assignment:
Enable or disable the Automatic IPv6 Address Assignment feature.
Autoconguration
Type:
Select SLAAC+RDNSS, SLAAC+Stateless DHCP, or Stateful DHCPv6.
If you selected SLAAC+RDNSS or Stateless DHCP as the Autoconfiguration Type:
Network (continued)