70D-Link DSL-G2452DG User Manual
Section 4 - Configuration
Note: If you enabled HTTPS Server and wish to access the router remotely
over an encrypted connection, you must enter https:// at the beginning
of the address.
SSH / Telnet / TFTP
If you want to allow router setup via the SSH, telnet, or TFTP protocols,
you can configure it here.
For each protocol, click Enable Local Management to allow
administrators to configure the network from within, and/or Enable
Remote Management to allow administrators to configure the network
from outside.
If you enabled remote management, enter the remote port number that
the router will use for that protocol.
Click Save when you are done.
Admin (cont)
To Next Page
Loading...
