Software User Manual D-Link Unified Access System
02/15/2011
Document 34CS3000-SWUM104-D10 Page 75
learns about an AP that is not in the database, and the AP has not tried to discover the switch, the AP appears in the list on
the Rogue/RF Scan Access page.
You can add the AP to the local Valid AP database from the list on the Authentication Failed Access Points page or the
Rogue/RF Scan Access page.
To add an AP from the Authentication Failed Access Points page or the Rogue/RF Scan Access page to the local Valid
AP database, use the following procedures:
1 Access either the Authentication Failed Access Points page or the Rogue/RF Scan Access page from the by clicking
Monitoring > Access Point folder.
2 Select the check box associated with the AP and click Manage.
3 The Valid Access Point Configuration page for the added AP is displayed.
Configure the appropriate fields, such as Location and Profile, and then click Submit.
The AP is added to the Valid AP database, and its MAC address appears in the list on the Administration > Basic Setup
> Valid AP page.
Note: You cannot add an AP to the RADIUS database from the AP authentication failure page. If you
use a RADIUS server for AP Validation, you must enter the AP information into the RADIUS
database.
Note: If you select multiple APs to manage, the Web interface displays the selected APs in the MAC Address field
one by one after you submit a configured AP entry.
To Next Page
Loading...
Need help?
General
