D-Link DWM-312 - Dynamic VPN Settings

26D-Link DWM-312 User Manual
Section 4 - Conguration
Dynamic VPN Settings
Tick this box to enable this feature and click More to congure
VPN Dynamic IP on a separate page. Please see the next page
for more details.
Enter a name for your VPN.
Enter the local (LAN) subnet. (ex. 192.168.0.0)
Enter the local (LAN) subnet mask. (ex. 255.255.255.0)
Enter the amount of time in seconds that the Phase 1 key should
last.
Enter the amount of time in seconds that the Phase 2 key should
last.
Choose either ESP, AH or ESP+AH from the drop-down menu.
Enable or Disable the PFS Group option using the drop-down
menu. PFS is an additional security protocol.
Check this box to enable aggressive mode.
Enter an ASCII passphrase in the box.
Choose from Username, FQDN, User@FQDN, or Key ID using
the drop-down menu and then enter an ID in the box.
Enabled:
Tunnel Name:
Local Subnet:
Local Netmask:
Pase1 Key Life
Time:
Phase2 Key Life
Time:
Encapsulation
protocol:
PFS Group:
Aggressive Mode:
Preshare Key:
Local ID: