D-Link NUCLIAS CONNECT DAP-2680 - Page 30

30D-Link DAP-2680 User Manual
Web User Interface
11n Preferred This function is only available when Connection Limit is enabled. Use the drop-down menu to enable the 11n Preferred function.
The wireless clients with 802.11n protocol will have higher priority to connect to the device.
Network Utilization Click the drop-down menu to set the maximum utilization of this access point for service. The DAP-2680 will not allow any new
clients to associate with the AP if the utilization exceeds the value the user species. When this network utilization threshold is
reached, the device will pause one minute to allow network congestion to dissipate.
Aging out Use the drop-down menu to select the criteria of disconnecting the wireless clients.
RSSI Threshold When Aging out is RSSI, click the drop-down menu to select the percentage of RSSI. When the RSSI of wireless clients is lower
than the specied percentage, the device disconnects the wireless clients. The function is only available when Aging out is RSSI.
Data Rate Threshold When Aging out is Data Rate, click the drop-down menu to select the threshold of data rate. When the data rate of wireless
clients is lower than the specied number, the device disconnects the wireless clients. The function is only available when Aging
out is Data Rate.
ACL RSSI Click the drop-down menu to enable the ACL RSSI function. When enabled, the device denies the connection request from the
wireless clients with the RSSI lower than the specied threshold below.
ACL RSSI Threshold Click the drop-down menu to set the ACL RSSI Threshold.
Save Click to save the updated conguration. To make the updates permanent, click Conguration > Save and Activate.