DAELIM S2 125 - Page 47

4-8
LUBRICATION SYSTEM
RADIATOR INSTALLATION
●Tighten the 3 radiator setting flange bolts to the main
pipe bracket.
•Oil level inspection must be performed in the flat
ground with the vehicle being straight by raising the
main stand.
RECOMMENDED OIL : SAE 80W/90
●Tighten the oil check bolt.
TORQUE VALUE : 0.9 kgf
·
m
●Start the engine and check for leak.
●Install the LH. crankcase cover. (⇨7-2)
TRANSMISSION OIL INSPECTION
●Remove the LH. crankcase cover. (⇨7-2)
●Check the body and the connection of each engine
component for any leak.
●Remove the oil check bolt and check to see if the oil
overflows from the oil check hole.
●If only the small amount of oil overflows. fill the
recommended transmission oil through the oil filler
hole gradually.
●Tighten the drain cock packings and oil bolts.
TORQUE VALUE : 3.2kgf
·
m
●Install the front wheel. (⇨12-4)
●Install the front cover. (⇨3-5)
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
FLANGE BOLTS
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
RADIATOR
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL BOLTS
OIL CHECK BOLT
BREATHER TUBE
A.C.GENERATOR CAP
•Pay attention not to turn over the vehicle.
•When installing the radiator, tighten the oil bolts
with specified tightening torque.