18-5
IGNITION SYSTEM
REPLACEMENT
Remove the high-tension cord from the plug, remove
the plug cap.
Remove the primary wire from the ignition coil.
Loosen the ignition coil mounting bolt securing the
frame, remove the ignition coil.
Install in the reverse order of removal.
SIDE STAND SWITCH
REMOVAL
Remove the RH side covver.
Remove the side stand switch couper connected with
main wire harness
Remove the side stand switch mounting screws and
remove the cord clamp and side stand switch.
BLACK/WHITE AND
GREEN TERMINAL
PUSH THE SHAFT
BLACK/WHITE AND
GREEN TERMINAL
RELEASE THE SHAFT
NORMAL IF THERE
IS CONTINUITY
NORMAL IF THERE
IS NO CONTINUITY
TERMINALS COLOR STANDARD
ITEM
SIDE STAND SWITCH
ON
(Side stand
erected)
PUSH
THE
SHAFT
RELEASE
THE
SHAFT
OFF
(Side stand
pull back)
INSPECTION
Check the following terminals.
Install in the reverse order of removal.
SHAFT
To Next Page