DAELIM VJF125 - Lubrication Points

LUBRICATION POINTS
3-6
LUBRICATION
Use general grease
Apply oil or grease to the other sliding surfaces not shown here.
SECTION ROTATE SHEEL ALVANIA EP2 or SUITABLENESS WIDTH
〃〃
SLIDING PART 〃
〃〃
EDGE PART 〃
SLIDING PART 〃
INSIDE PART OF MASTER CYLINDER CUP DOT3 or DOT 4
SLIDING PART
ASSEMBLY OIL CCI No.20 or SUITABLENESS WIDTH
〃 BRAKE GREASE SPECIAL
〃〃
EDGE PART
ASSEMBLY OIL CCI No.20 or SUITABLENESS WIDTH
SLIDING PART MITSUBISHI MULTIPURPOSE No.20 or SUITABLENESS WIDTH
EDGE PART 〃
GEAR COUPLING
DAPHNE EPONEX EP2 or SUITABLENESS WIDTH
INSIDE ULTRA CUSH OIL NO.10 SUITABLENESS WIDTH
EDGE PART LIQUID O-RING #400
SLIDING PART GREASE
CONCORDANT PART
CEMEDINE #540 or SUITABLENESS WIDTH
SLIDING PART MITSUBISHI MULTIPURPOSE No.20 or SUITABLENESS WIDTH
CASTING AND CONTACT INSIDE PART SILICON GREASE
CASTING
INSIDE PART 〃
SLIDING PART
MITSUBISHI MULTIPURPOSE No.20 or SUITABLENESS WIDTH
〃
MITSUBISHI MULTIPURPOSE No.20 or SUITABLENESS WIDTH
〃 MITSUBISHI MULTIPURPOSE No.20 or SUITABLENESS WIDTH