DAELIM VJF125 - Gear Change Switch; Horn; Winker Relay

20-8
LIGHTS/SWITCHES/HORN
WINKER RELAY
Remove the rear seat. (⇨13-2)
Check the following:
- Battery condition
- Burned bulbs
- Burned fuse
- Main switch and winker switch function
- Loose connectors
If the above items are all normal, check the following:
1. Short the Black and Gray terminals of the winker relay
connector with a jumper wire.
Start the engine and check the winker light by
turning the switch to ON.
Light comes on Light does not come on
•Faulty winker relay
•Poor connection of the connector
•Broken wire harness
GEAR CHANGE SWITCH
Remove the seat. (13-2)
Remove the LH. side cover. (13-2)
Disconnect the neutral switch connector from the
switch.
Shift the transmission into neutral and check for
continuity between the green/white wire terminal and
ground.
There should be continuity with the transmission is in
neutral, and no continuity when the transmission is into
gear.
HORN
Disconnect the wire connectors from the horn.
Connect the 12V battery to the horn terminal directly.
The horn is normal if it sounds when the 12V battery is
connected acress the horn terminals.