Local Configurations 204
Select the check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured
in Main Menu > DISPLAY > TOUR.
Select to enable audio broadcast/voice prompts in response to a
temperature alarm event.
Show Message: Select the Show Message check box to
enable a pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the
Device.
Video Matrix: Select the check box to enable the function.
When an alarm event occurs, the video output port outputs the
settings configured in "Main Menu > DISPLAY > TOUR."
Not all models support this function.
Send Email: Enable the system to send an email notification
when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL.
Log: Select the check box to enable the Device to record a
Table 5-51
Click Save to save the settings. Step 4
5.13.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
On the main interface, select IoT > MANAGER > Temperature/Humidity. Step 1
The Temperature/Humidity interface is displayed. See Figure 5-177.
To Next Page
Loading...
Need help?
General
