158
For the LAN mode, after you logged in, you can see the main window. See Figure 5-9.
Figure 5-9
This main window can be divided into the following sections.
Section 1: there are six function buttons: Live（chapter 5.6）, setup (chapter 5.10), info (Chapter 5.11),
playback (chapter 5.12), alarm (chapter 5.13), and logout (chapter 5.14).
Section 2: There are monitor channels successfully connected to the NVR.
Please refer to Figure 5-10 for main stream and extra stream switch information.
Figure 5-10
Section 3: Open all. Open all button is to enable/disable all-channel real-time monitor. Here you can
select main stream/sub stream too. See Figure 5-11.
Figure 5-11
Section 4: Start Talk button.
You can click this button to enable audio talk. Click 【▼】 to select bidirectional talk mode. There are four
options: DEFAULT, G711a, G711u and PCM. See Figure 5-12.
After you enable the bidirectional talk, the Start talk button becomes End Talk button and it becomes
To Next Page
Loading...
