53
Figure 4-17
Step 3 Set parameters.
IP Version: There are two options: IPv4 and IPv6. Right now, system supports these two IP
address format and you can access via them.
MAC address: The host in the LAN can get a unique MAC address. It is for you to access in
the LAN. It is read-only.
IP address: Here you can use up/down button () or input the corresponding number to
input IP address. Then you can set the corresponding subnet mask the default gateway.
Default gateway: Here you can input the default gateway. Please note system needs to
check the validity of all IPv6 addresses. The IP address and the default gateway shall be in
the same IP section. That is to say, the specified length of the subnet prefix shall have the
same string.
MTU: It is to set MTU value of the network adapter. The value ranges from 1280-7200 bytes.
The default setup is 1500 bytes.
Step 4 Click OK to complete the settings.
4.1.4.3 P2P
Click Next button, you can set P2P function. Scan the QR code, download the App to the cell phone, you
can use the smart phone to add the device.
Scan the QR code on the actual interface to download the cell phone app. Register an account and
then use.
Go to the www.easy4ip.com to register an account and use the SN to add a device. Refer to the P2P
operation manual for detailed information.
To Next Page
Loading...
Need help?
General