58
We recommend click Connect button to get remote device channel amount, the manual add
operation may result in failure if the input channel amount is not right.
Remote channel No.: After getting the remote device channel amount, click Setup to
select a channel.
Note
Click to select one or more remote channel numbers here.
Channel: The local channel number you want to add. One channel name has
corresponding one channel number.
Decode buffer: There are three items: realtime,local,fluent.
Service type: There are four items: auto/TCP/UDP/MULTICAST(ONVIF device only)
Note
The default connection mode is TCP if the connection protocol is private.
There are four types including Auto, TCP, UDP and MULTICAST if the connection protocol
is ONVIF.
There are two types including TCP and UDP if the connection protocol is customized.
Encrypt: When the connection protocol is ONVIF, enable the encryption function and
system transmits data in the encrypted mode.
Note
HTTPS shall be enabled in IPC to support encryption.
Figure 4-22
To Next Page
Loading...
Need help?
General