User's Manual
90
4 Local Basic Operation
Slight difference may be found on the user interface. The following figures are for reference
only.
4.1 Getting Started
This chapter introduces device initial settings such as boot up, device initialization, reset
password, and quick settings.
4.1.1 Booting up
● For device security, connect the NVR to the power adapter first and then connect the
device to the power socket.
● The rated input voltage matches the device power button. Make sure the power wire
connection is OK. Then click the power button.
● Always use the stable current, if necessary UPS is a best alternative measure.
Step 1 Connect the device to the monitor and then connect a mouse.
Step 2 Connect power cable.
Step 3 Click the power button at the front or rear panel and then boot up the device.
After device booted up, the system is in multiple-channel display mode by default.
4.1.2 Device Initialization
If it is your first time to use the device, set a login password of
admin
(system default user).
You can select to use unlock pattern to login or not at your own choosing.
For your device safety, keep your login password of
admin
well after the initialization steps,
and change the password regularly.
Step 1 Boot up NVR.
The
Device Initialization
interface is displayed. See Figure 4-1
To Next Page
Loading...
Need help?
General
