User's Manual
93
● The pattern that you want to set must cross at least four grids.
● If you do not want to configure the unlock pattern, click
Skip
.
● Once you have configured the unlock pattern, the system will require the unlock
pattern as the default login method. If you skip this setting, enter the password for
login.
Figure 4-4
Step 7 Set security questions. See Table 4-2.
● After configuration, if you forgot the password for admin user, you can reset the
password through the reserved email address or security questions. For details
about resetting the password, see "4.1.3 Resetting Password".
● If you do not want to configure the settings, disable the email address and security
questions functions on the interface.
Table 4-2
Enter the reserved email address.
In the Email Address box, enter an email address for password
reset. If you forget the password, enter the security code that
you will get from this reserved email address to reset the
password of admin. Refer to "4.16.1.2 Modify Password" for
detailed information.
Configure the security questions and answers.
If you forget the password, enter the answers to the questions
can allow you reset the password. Refer to " 4.15.3 Reset
Password " for detailed information.
Step 8 Click
Save
to complete the device initialization setup.
Step 9 Device goes to startup wizard interface. Refer to "4.1.4 Quick Settings" for detailed
information.
4.1.3 Resetting Password
You can reset the password by the following methods when you forgot the password for admin
To Next Page
Loading...
Need help?
General
