User's Manual
348
Figure 4-250
Step 2 Select
Basic Services
and configure parameters.
There might be safety risk when
Mobile Push Notifications
,
CGI
,
ONVIF
,
SSH
and
NTP Server
is enabled.
Table 4-81 Basic service parameters
Mobile Push
Notifications
After enabling this function, the alarm triggered by the NVR can
be pushed to a mobile phone. This function is enabled by
default.
If this function is enabled, the remote devices can be added
through the CGI protocol. This function is enable by default.
If this function is enabled, the remote devices can be added
through the ONVIF protocol. This function is enabled by default.
After enabling this function, a NTP server can be used to
synchronize the device. This function is enabled by default.
After enabling this function, you can use SSH service. This
function is disabled by default.
After enabling this function, the NVR can be found by other
devices trough searching.
Private Protocol
Authentication Mode
● Security Mode (Recommended): Uses Digest access
authentication when connecting to NVR.
● Compatible Mode: Select this mode when the client does
not support Digest access authentication.
Step 3 Click
Apply
to complete the settings.
To Next Page
Loading...
Need help?
General
