Daikin Altherma 3 GEO Series - System Information

9 | LAN adapter
Installer reference guide
115
EGSAH/X06+10UDA9W
Daikin Altherma 3 GEO
4P598592-1A – 2019.12
Retrieval via Instruction
The Daikin Residential Controller app ▪ From the app's home screen, tap the
pencil icon to go to the "Edit unit"
screen.
▪ Under "Units", tap a unit that is
connected to the LAN adapter of
which you want to retrieve the IP
address.
▪ In the "Manage unit" screen, find the
LAN adapter IP address under
"Network gateway information".
The DHCP client list of your router Find the LAN adapter in the DHCP client
list of the router.
Access via DIP switch + custom static IP address
Prerequisite: Your computer is directly connected to the LAN adapter with an
Ethernet cable, and is NOT connected to any network (wifi, LAN, …).
Prerequisite: The power to the LAN adapter is OFF.
1 Set DIP switch 4 to "ON".
2 Turn ON the power to the LAN adapter.
3 In your browser, go to http://169.254.10.10.
NOTICE
Use appropriate tooling to set the DIP switches to another position. Beware of
electrostatic discharge.
INFORMATION
The LAN adapter only checks the configuration of the DIP switch after a power reset.
To configure the DIP switch, therefore make sure the power to the adapter is OFF.
INFORMATION
"Power" is both the power supplied by the indoor unit AND the 230VAC detection
voltage supplied to X1A.
9.4.6 System information
To consult system information, go to "Information" on the configuration web
interface.