Daikin intelligent Touch Manager - Page 4

4 Installation Manual 3P291714-2B
DCM601A71 intelligent Touch Manager
English
CAUTION
• Keep water out of the controller.
• To avoid electric shock due to entry of water or insects, ll the wiring through-
hole with putty.
• Do not wash the controller with water as it may result in electrical shocks or
re.
• Do not touch the controller buttons with wet ngers.
Touching the buttons with wet ngers can cause an electric shock.
• Do not install the controller in the following locations:
(a) Where a mineral oil mist or oil spray or vapor is produced, for example, in a
kitchen.
Plastic parts may deteriorate and fall off.
(b) Where corrosive gas, such as sulfurous acid gas, is produced.
(c) Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation of the control system and cause
the unit to malfunction.
(d) Where ammable gas may leak, where there is carbon ber or ignitable dust
suspensions in the air, or where volatile ammables such as thinner or gaso-
line are handled.
Operating the unit in such conditions can cause a re.
(e) High temperature area or directly amed point.
Heating and/or re can occur.
(f) Moist area, where there is exposure to water.
If water enters the inside of the controller, it may cause electric shock and electrical
components may fail.
NOTE
• Install the control wires for the controller at least 3.5 feet (1 meter) away from
televisions or radios to prevent image interference or noise.
Depending on the radio waves, a distance of 3.5 feet (1 meter) may not be sufcient
to eliminate the noise.