A·X·U·M User Manual Version 2.5 - 2011-01-28
AXUM from D&R - Phone: +31 294 418014 - E-Mail: info@d-r.nl - 105 -
Example object to connect to
This function shows a ‘1’ if the fader and on are
inactive.
When received a ‘1’ the fader and on are made
This function shows a ‘1’ if the fader and on are
active.
When received a ‘1’ the ‘fader and on’-state toggles
between active and inactive
This function handles like a fader-on-switch (press =
This function handles like a fader-off-switch (press =
This function handles like a fader on/off-switch (press
= toggle between fader 0 dB and off)
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Buss 1/2 on Select the buss on Switch 2.2
Buss 1/2 pre Select if this module sent pre or post fader signal to
Switch 2.0
Buss 1/2 balance The balance of the module signal sent to the buss Encoder 2.0
This resets the balance to the center position
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Buss 3/4 on Select the buss on Switch 2.2
Buss 3/4 pre Select if this module sent pre or post fader signal to
Switch 2.0
Buss 3/4 balance The balance of the module signal sent to the buss Encoder 2.0
This resets the balance to the center position
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Buss 5/6 on Select the buss on Switch 2.2
Buss 5/6 pre Select if this module sent pre or post fader signal to
Switch 2.0
Buss 5/6 balance The balance of the module signal sent to the buss Encoder 2.0
This resets the balance to the center position
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Buss 7/8 on Select the buss on Switch 2.2
Buss 7/8 pre Select if this module sent pre or post fader signal to
Switch 2.0
Buss 7/8 balance The balance of the module signal sent to the buss Encoder 2.0
This resets the balance to the center position
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Buss 9/10 on Select the buss on Switch 2.2
Buss 9/10 pre Select if this module sent pre or post fader signal to
Switch 2.0
Buss 9/10 balance The balance of the module signal sent to the buss Encoder 2.0
This resets the balance to the center position
Controls the sent level to the buss for this module
Select ‘Off ‘or ‘On = 0 dB’ depending on current state
Select if this module sent pre or post fader signal to
the buss
To Next Page
Loading...
