Danfoss Metasys N2 Programming Guide

2-16 AC brake Max. Current
Range: Function:
100 %* [ 0 - 1000.0
%]
NOTICE
Parameter 2-16 AC brake Max.
Current does not have eect when
parameter 1-10 Motor
Construction=[1] PM, non-salient
SPM.
Enter the maximum permissible current
when using AC brake to avoid
overheating of motor windings.
2-17 Over-voltage Control
Over voltage control (OVC) reduces the risk of the frequency
converter tripping due to an over voltage on the DC link caused
by generative power from the load.
Option: Function:
NOTICE
The ramp time is automatically adjusted to
avoid tripping of the frequency converter.
[0] Disabled No OVC required.
[2] * Enabled Activates OVC.
Parameter Descriptions Programming Guide
MG11CE02 Danfoss A/S © 03/2015 All rights reserved. 57
3 3

Danfoss Metasys N2 Specifications

General

Brand	Danfoss
Model	Metasys N2
Category	DC Drives
Language	English