95 of 114M-AP-001-EN Rev. Q
THIS PAGE INTENTIONALLY LEFT BLANK
Chapter 18.0 Environmental Considerations
18.1 Humidity
If the compressor is installed in a humid environment, drip trays may be required to collect
condensate. Insulation should be installed on the suction valve/piping and the end cap as this is
where condensation is most likely to form.
It is recommended to fit an End Cap insulator in a humid environment.
NOTE
The End Cap insulator is not available for TGH/TTH compressors.
18.2 Vibration
External copper piping should be braced to minimize the transfer of vibration to the compressor.
To Next Page
Loading...
