Parameter 700 -
Only for wobble functions: To use this function or for
further information, see Wobble Function Instruction.
678 Configure Control Card
Value:
Standard version (STANDARD VERSION) [1]
Profibus 3 Mbaud Version (PROFIBUS 3 MB Ver.) [2]
Profibus 12 Mbaud Version (PROFIBUS 12 MB Ver.) [3]
Function:
Configure a Profibus control card. The default value
depends on the produced unit, also being the maximum
obtainable value. This means that a control card only can
be downgraded to a lower performance version.
Programming Design Guide
126 Danfoss A/S © Rev. May/2014 All rights reserved. MG27E402
44
To Next Page
Loading...
Need help?
General