Danfoss VLT AQUA Drive FC 202

-
-
-
-
-
-
W A R N I N G
ROTATING SHAFTS
Contact with rotating shafts and electrical equipment can result in death or serious injury.
Ensure that only trained and qualied personnel perform installation, start-up, and maintenance.
Ensure that electrical work conforms to national and local electrical codes.
Follow the procedures in this guide.
C A U T I O N
HOT SURFACES
The drive contains metal components that are still hot even after the drive has been powered o. Failure to observe the high
temperature symbol (yellow triangle) on the drive can result in serious burns.
Be aware that internal components, such as busbars, may be extremely hot even after the drive has been powered o.
Do not touch exterior areas that are marked by the high temperature symbol (yellow triangle). These areas are hot while the
drive is in use and immediately after being powered o.
C A U T I O N
INTERNAL FAILURE HAZARD
An internal failure in the drive can result in serious injury when the drive is not properly closed.
Ensure that all safety covers are in place and securely fastened before applying power.
AQ262141056213en-000201 / 130R088212 | Danfoss A/S © 2020.09
Safety
VLT® AQUA Drive FC 202
Operating Guide