Danfoss VLT AQUA Drive FC 202 Operating Manual

1 Introduction
1.1 Purpose of the Manual
This operating guide provides information for safe instal-
lation and commissioning of the VLT
®
drives.
The operating guide is intended for use by qualied
personnel. To use the unit safely and professionally, read
and follow this operating guide. Pay particular attention to
the safety instructions and general warnings. Always keep
the operating guide with the drive.
VLT
®
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand advanced
drive functions and programming.
•
The programming guide provides greater detail on
working with parameters and many application
examples.
•
The design guide provides detailed information
about capabilities and functionality to design
motor control systems.
•
Instructions provide information for operation
with optional equipment.
Supplementary publications and manuals are available
from Danfoss. See drives.danfoss.com/knowledge-center/
technical-documentation/ for listings.
1.3
Manual and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.1 shows
the version of the manual and the corresponding software
version.
Manual version Remarks Software version
MG21A5xx Replaces MG21A4xx 3.23
Table 1.1 Manual and Software Version
1.4
Approvals and Certications
Table 1.2 Approvals and
Certications
More approvals and certications are available. Contact the
local Danfoss oce or partner. Drives of voltage 525–690 V
are UL certied for only 525–600 V.
The drive complies with UL 61800-5-1 thermal memory
retention requirements. For more information, refer to the
section Motor Thermal Protection in the product-specic
design guide.
NOTICE
OUTPUT FREQUENCY LIMIT
Due to export control regulations, the output frequency
of the drive is limited to 590 Hz. For demands exceeding
590 Hz, contact Danfoss.
1.4.1 Compliance with ADN
For compliance with the European Agreement concerning
International Carriage of Dangerous Goods by Inland
Waterways (ADN), refer to ADN-compliant Installation in the
design guide.
1.5
Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction VLT® AQUA Drive FC 202
4 Danfoss A/S © 09/2018 All rights reserved. MG21A502
11

Danfoss VLT AQUA Drive FC 202 Specifications

General

Brand	Danfoss
Model	VLT AQUA Drive FC 202
Category	DC Drives
Language	English