Danfoss VLT AQUA FC 202 - Page 162

e30bh324.10
Reference range = Minimum to maximum
Resulting reference
Forward
Reverse
Minimum reference
Maximum reference
-Minimum reference
-Maximum reference
Sum of all
references
Illustration 87: Sum of All References When Reference Range is Set to 0
e30bh325.10
Reference range = -Maximum to +maximum
Resulting reference
Maximum reference
-Maximum reference
Sum of all
references
Illustration 88: Sum of All References When Reference Range is Set to 1
The minimum reference cannot be set to less than 0, unless the conguration mode is set to Process. In that case, the following
relations between the resulting reference (after clamping) and the sum of all references are as shown in Illustration 89.
e30bh326.10
Reference range = Minimum to maximum
Resulting reference
Maximum reference
Minimum reference
Sum of all
references
Illustration 89: Sum of all References when Conguration Mode is set to Process
AJ300847815559en-000101 / 130R0337162 | Danfoss A/S © 2020.09
Basic Operating Principles
VLT® AQUA Drive FC 202
Design Guide