Danfoss VLT FC 103 - Tightening Torques; Electrical Installation

NOTICE!
Backplate is needed when mounted on railings.
2.3.4 Tightening Torques
See chapter 10.4 Connection Tightening Torques for proper tightening specifications.
2.4 Electrical Installation
This section contains detailed instructions for wiring the adjustable frequency drive. The following tasks are described:
•
Wiring the motor to the adjustable frequency drive output terminals
•
Wiring the AC line power to the adjustable frequency drive input terminals
•
Connecting control and serial communication wiring
•
After power has been applied, checking input and motor power; programming control terminals for their intended
functions
Installation Instruction Manual
10 Danfoss A/S © Rev. 2014-02-10 All rights reserved. MG16E222
22