3.9 System Start-up
The procedure in this section requires user-wiring and
application programming to be completed.
chapter 6 Application Set-up Examples is intended to help
with this task. Other aids to application set-up are listed in
chapter 6 Application Set-up Examples. The following
procedure is recommended after application set-up by the
user is completed.
CAUTION
MOTOR START!
Ensure that the motor, system and any attached
equipment is ready for start. It is the responsibility of the
user to ensure safe operation under any condition.
Failure to do so could result in personal injury or
equipment damage.
1. Press [Auto On].
2. Ensure that external control functions are
properly wired to the adjustable frequency drive
and all programming completed.
3. Apply an external run command.
4. Adjust the speed reference throughout the speed
range.
5. Remove the external run command.
6. Note any problems.
If warnings or alarms occur, see chapter 8 Warnings and
Alarms.
Start-up and Functional Tes... Instruction Manual
MG16E222 Danfoss A/S © Rev. 2014-02-10 All rights reserved. 41
3 3
To Next Page
Loading...
Need help?
General