Danfoss VLT FC 103 Instruction Manual

2.
Mount cable clamp to ensure 360° connection
between chassis and shield, note the outer
insulation of the motor cable is removed under
the clamp.
130BA266.10
+DC
BR-
B
MAINS
L1 L2 L3
91 92 93
RELAY 1 RELAY 2
99
- LC -
UVW
MOTOR
Figure 2.15 Cable Clamp Mounting
2.4.4.2
Motor Connection for A4 and A5
1. Terminate the motor ground
2. Place motor U, V and W wires in terminal and
tighten
3. Ensure that the outer insulation of the motor
cable is removed under the EMC clamp
U
V
W
96
97
98
130BT337.10
Figure 2.16 Motor Connection for A4 and A5
2.4.4.3
Motor Connection for B1 and B2
1. Terminate the motor ground
2. Place motor U, V and W wires in terminal and
tighten
3. Ensure that the outer insulation of the motor
cable is removed under the EMC clamp
130BT333.10
Figure 2.17 Motor Connection for B1 and B2
Installation Instruction Manual
18 Danfoss A/S © Rev. 2014-02-10 All rights reserved. MG16E222
22

Danfoss VLT FC 103 Specifications

General

Brand	Danfoss
Model	VLT FC 103
Category	DC Drives
Language	English