PRODUCT REFERENCE GUIDE
5
CHAPTER 2
SETUP
UNPACKING
Check carefully to ensure the reader and any cables or accessories ordered are present
and undamaged. If any damage occurred during shipment, contact "
Technical Support"
on page xiv
.
SETTING UP THE CODISCAN™ HS7600 READER
Follow the steps below to connect and get your reader up and communicating with its
host.
1. Charge the device on a charging station (optional).
2. Mount the device onto the preferred mounting support (optional). See "
Mounting
the Reader" on page 8
.
3. Connect to host with pairing barcode. See
Linking the Reader on page 14. If it has
not been previously linked to a host, the device will be in discoverable HOGP
mode when it is powered on. The rear blue LED will flash for 3 minutes.
4. Configure (optional).
To Next Page
Loading...
