LINKING THE READER
PRODUCT REFERENCE GUIDE
15
Link Reader as HOGP device to a Bluetooth (LE) host
Use this procedure to let the CODiScan HS7600 send data to a Bluetooth host using the
Bluetooth HOGP profile.
1. If using a Bluetooth adapter on the host device, install any driver provided with
the adapter.
2. Scan the Link to Host in HOGP Mode label below to make the reader visible to the
host device.
3. Use the Bluetooth manager of the host device to "Discover new devices" and
select "HS7600…". If you receive an error message, it may be necessary to change
the security settings on either the host device or the reader.
4. On the host device, open the program that is meant to receive the incoming data.
The data transmitted by the reader will appear in the program as if it was typed using
the keyboard of the host device.
Link to Host in HOGP Mode
NOTE: The CODiScan HS7600 can be set up to authenticate the remote sys-
tem when connecting, by entering a Bluetooth passkey or a PIN code. If you
want to set the security level and authentication options suitable for your
application, or when adding new equipment to a system that requires
authentication or uses a custom security PIN, please see
"Bluetooth Secu-
rity Level"
on page 227
NOTE: The CODiScan HS7600 can be set up to authenticate the remote sys-
tem when connecting, by entering a Bluetooth passkey or a PIN code. If you
want to set the security level and authentication options suitable for your
application, or when adding new equipment to a system that requires
authentication or uses a custom security PIN, please see
"Bluetooth Secu-
rity Level"
on page 227
To Next Page
Loading...
