Datalogic CODiScan HS7600 - LED and Beeper Indications; User Indications for HS7600

TECHNICAL SPECIFICATIONS
270 CODISCAN™ HS7600
LED AND BEEPER INDICATIONS
The reader’s beeper sounds and its illumination flashes or changes color to indicate var-
ious functions or errors on the reader. A “Green Spot” also lights to indicate a good
read. The tables below list these indications.
Table 24LED and Beeper Indications
USER INDICATIONS FOR HS7600
Table 25 User Indications for HS7600
INDICATION LED BEEPER
Power-up
Upper LED flashes/blinks on power-up.
With a USB interface, the LED blinks
until enumeration with the host is com-
pleted.
The rear LED will turn blue for 2 and a
half minutes in discoverable HOGP
mode if not previously linked to a host.
Reader beeps four times at highest fre-
quency and volume upon power-up.
Good Read
Upper green LED comes on for pro-
grammed time (default).
LED behavior for this indication is con-
figurable using Aladdin utility.
One beep at current frequency, volume,
mono/bi-tonal setting upon a successful
label scan.
ROM Failure
200 msec on
↔ 200 msec off
Reader sounds one error beep at highest
volume for 200 msec.
Limited Scanning Label
Read
N/A
Reader 'chirps' six times at the highest fre-
quency and current volume.
Imager Disabled
The LED blinks continuously
100 msec on
↔ 900 msec off
N/A
STATUS GOOD READ LED BATTERY LED BUZZER
Power-up OFF OFF
Rising Beeps’
Sequence
USB Enumeration Phase
250 msec
a
ON ↔ 250 msec OFF
OFF OFF
While Reading OFF OFF OFF
Decode Done
Solid ON
Programmable Duration (1 s
default)
OFF Single Beep
Reader Disabled (POS)
Communication with host
not established
100 msec ON
↔ 900 msec OFF
OFF OFF
Firmware Upgrade
250 msec ON
↔ 250 msec OFF
OFF OFF
Host Download
250 msec ON
↔ 250 msec OFF
OFF OFF
Paging Answer
5 cycles:
100 msec ON
↔ 900 msec OFF
OFF
5 Beeps
(when LED ON)
Enter Service Mode No Effect OFF Beeps' Sequence
Label Programming No Effect OFF Beep