SETUP
6
CODISCAN™ HS7600
USING THE CODISCAN™ HS7600
The CODiScan™ HS7600 normally functions by capturing and decoding codes.
Turn the scanner by pressing the multi-functional button or the trigger. When the scan-
ner starts up, it vibrates.
The reader is equipped with an aiming system. A partial press on the hand trigger will
activate the aiming system without the illuminator. The intelligent aiming system indi-
cates the field of view which should be positioned over the bar code.
CODiScan HS7600 Aiming System
The field of view indicated by the aiming system will be smaller when the reader is
closer to the bar code and larger when it is farther from the code. Symbologies with
smaller bars or elements (mil size) should be read closer to the unit. Symbologies with
larger bars or elements (mil size) should be read farther from the unit.
Successful reading is signaled by an audible tone plus a good-read green spot LED indi-
cator and vibration.
If enabled, when you use the device with the hand trigger, a partial trigger press pro-
duces the image shown above, which should be aimed over the code center to get the
best reading performance. By completely pressing the trigger the illumination area
appears and the code scanning starts.
Refer to "
Aiming Pointer" on page 92 to enable or disable the Aiming pointer.
CHARGING THE BATTERIES
Charge the CODiScan HS7600 by simply inserting it into one of the available chargers:
• SC-HS7600: USB Cap Charger 1 slot
• MC-HS7600: Charging station 2-slot module
• MC-12HS7600: Charging station 12-slot module
When the scanner is fully seated in the charging station, it will emit a “chirping” sound
to indicate that it has detected the connection with the charging station.
The LEDs on the device will indicate the status of the battery. For information about the
LEDs see Table 1 on page 18.
For more information on the chargers and their use, please refer to the Charger Instruc-
tion Manual.
NOTE: The Aiming System is activated by partially presssing the hand trig-
ger. It is not activated by pressing the multifunction button on the device.
To Next Page
Loading...
