Datalogic CODiScan HS7600 - Disable Character; Enable Character

USB-COM SETTINGS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 35
Disable Character
Specifies the value of the USB COM host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
Disable Character"
on page 244
for more detailed programming instructions.
Enable Character
Specifies the value of the USB COM host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
Enable Character"
on page 245
for more detailed programming instructions
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
Select Disable Character Setting
$CR2DC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

0x44 = Disable Character is ‘D’
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters.
Select Enable Character Setting
$CR2EC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

0x45 = Enable Character is ‘E’