Datalogic CODiScan HS7600 - Chapter 3; Configuration with Bar Codes; Configuration Parameters; Gateway Interface Configuration:

PRODUCT REFERENCE GUIDE 25
CHAPTER 3
CONFIGURATION WITH BAR CODES
This and following sections provide programming bar codes to configure your reader by
changing the default settings. For details about additional methods of programming,
see "
Customizing Configuration Settings" on page 22.
CONFIGURATION PARAMETERS
Once the reader is set up, you can change the default parameters to meet your applica-
tion needs. Refer to
Standard Defaults, starting on page 277 for initial configuration in
order to set the default values and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to
find the desired function based on its reference group.
Gateway Interface Configuration:
• USB-COM Settings, starting on page 29
• Keyboard Interface, starting on page 37
• USB-OEM Interface, starting on page 64
Parameters common to all interface applications:
• Global Prefix/Suffix, starting on page 67
• Data Format, starting on page 66 gives options to control the messages sent to the
Host system by selecting parameters to control the message strings sent to the
handheld.
• Reading Parameters, starting on page 77 controls various operating modes and
indicators status functioning.
NOTE: You must first enable your CODiScan to read bar codes in order to
use this section. If you have not done this, go to
Setup, starting on page 5
and complete the appropriate procedure.
NOTE: In the following sections, text shown with a green star indicates a
factory default value.

This is an example of a default value.