PRODUCT REFERENCE GUIDE
277
APPENDIX B
STANDARD DEFAULTS
The most common configuration settings are listed in the “Default” column of the table
below. Page references are also provided for feature descriptions and programming bar
codes for each parameter. A column has also been provided for recording of your pre-
ferred default settings for these same configurable features.
Table 26 Standard Defaults
PARAMETERS DEFAULT
YOUR SETTING PAGE NUMBER
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore Obey 27
USB-COM
Intercharacter Delay No Delay 29
Beep On ASCII BEL Disable 30
Beep On Not on File Enable 30
ACK NAK Options Disable 31
ACK Character ‘ACK’ 32
NAK Character ‘NAK’ 32
ACK NAK Timeout Value 200 msec 33
ACK NAK Retry Count 3 Retries 32
ACK NAK Error Handling Ignore Errors Detected 34
Indicate Transmission Failure Enable 34
Disable Character ‘D’ 35
Enable Character ‘E’ 35
KEYBOARD INTERFACE
Setting Country Mode
U.S. Keyboard 39
Encoding Type Don't Use Encoding 53
ALT Output Type ALT Unicode 60
To Next Page
Loading...
