CLEANING PROCEDURE
PRODUCT REFERENCE GUIDE
273
CLEANING PROCEDURE
Exterior surfaces and scan windows exposed to spills, smudges or debris accumulation
require periodic cleaning to ensure best performance during scanning operations. Fol-
low the procedures described in this instruction sheet to keep your CODiScan device in
good operating condition
Common Cleaning Solutions
The cleaners and disinfectants listed below are recommended for use on Datalogic’s
CODiScan enclosures:
WARNING: Be sure to turn off power and unplug the device from electrical
outlet before cleaning.
CAUTION: DO NOT use abrasive pads or cleaning agents.
CLEANERS DISINFECTANTS
Formula 409® Glass and
Surface Cleaner
Clorox® Bleach (diluited 10:1)
70% Isopropyl Alcohol Hydrogen Peroxide 3%
Windex® Multi-Surface
100% Gentle dish soap
and water
NOTE: Disinfectants may be harsh on metal. They are recommended for use
only on enclosures
CAUTION: DO NOT spray or pour cleaner directly onto the unit.
DO NOT use solutions in their concentrated form.
DO NOT use aerosols, solvents or abrasives.
DO NOT use paper towels or rough cloths to clean windows.
DO NOT use products containing chlorine.
To Next Page
Loading...
