CUSTOMIZING CONFIGURATION SETTINGS
PRODUCT REFERENCE GUIDE
23
Interface Settings
The reader is typically factory-configured with a set of default features standard to the
interface type you ordered. See
Appendix B, Standard Defaults.
Global Interface Features, starting on
page 25 provides settings configurable by all inter-
face types. If your installation requires you to further customize your reader, you can
select other options through use of the instructions and programming bar codes avail-
able in the appropriate section for your interface.
• "
USB-COM Interfaces" on page 28
• USB Composite (COM + Keyboard) on page 21
• KEYBOARD INTERFACE on page 37
• USB-OEM INTERFACE on page 64
Configuring Other Features
If your installation requires different programming than the standard factory default
settings, the following sections of this manual allow configuration of non-interface-spe-
cific settings you might require:
Configuration Using Bar Codes:
General Features includes programming for scanning,
beeper and LED indicators and other such universal settings.
Reading Parameters:
Reading Parameters include programming for scanning, beeper
and LED indicators and other universal settings.
1D Symbologies:
Includes options concerning the bar code label types (symbologies).
These settings allow you to enable/disable symbologies, set label lengths, require check
digit, etc.
2D Symbologies:
Includes options concerning the bar code label types (symbologies).
These settings allow you to enable/disable symbologies, set label lengths, require check
digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the Bluetooth interfaces by
scanning the following label.
Transmit Software Version
To Next Page
Loading...
